Article

Pawar, M J and Patnaik, A. and Biswas, S K and Pandel, U and Bhat, I K and Chatterjee, S and Mukhopadhyay, Anoop Kumar and Banerjee, R and Babu, B P (2016) Comparison of ballistic performances of Al2O3 and AlN ceramics. International Journal of Impact Engineering, 98. pp. 42-51. ISSN 0734-743X

Ghanty, C and Chatterjee, S and Basu, Rajendra Nath and Majumder, S B (2013) Effect of structural integration on electrochemical properties of 0.5Li(2)MnO(3)-Li-0.5(Mn0.375Ni0.375Co0.25)O-2 composite cathodes for lithium rechargeable batteries. Journal of the Electrochemical Society, 160 (9). A1406-A1414. ISSN 0013-4651

Gangopadhyay, Tarun Kumar and Chakravorti, S and Chatterjee, S and Bhattacharya, K (2006) Time-frequency analysis of multiple fringe and nonsinusoidal signals obtained from a fiber-optic vibration sensor using an extrinsic Fabry-Perot interferometer. Journal of Lightwave Technology, 24 (5 ). pp. 2122-2131. ISSN 0733-8724

Pal, Mrinmay and Sen, Ranjan and Paul, Mukul Chandra and Bhadra, Shyamal Kumar and Chatterjee, S and Ghosal, D and Dasgupta, Kamal (2005) Investigation of the deposition of porous layers by the MCVD method for the preparation of rare-earth doped cores of optical fibres. Optics Communications, 254 (1-3). pp. 88-95. ISSN 0030-4018

Bhadra, Shyamal Kumar and Sen, Ranjan and Pal, Mrinmoy and Paul, Mukul Chandra and Naskar, Milan Kanti and Chatterjee, S and Chatterjee, Minati and Dasgupta, Kamal (2003) Development of rare-earth doped fibres for amplifiers in WDM systems. IEE Proceedings-Circuits Devices and Systems, 150 (6). pp. 480-485. ISSN 1350-2409

Chatterjee, K and Chatterjee, S and Banerjee, A and Raut, Minu and Pal, N C and Sen, Amarnath and Maiti, Himadri Sekhar (2003) The effect of palladium incorporation on methane sensitivity of antimony doped tin dioxide. Materials Chemistry and Physics, 81 (1). pp. 33-38. ISSN 0254-0584

Chatterjee, S and Stojanovic, BD and Maiti, Himadri Sekhar (2003) Effect of additives and powder preparation techniques on PTCR properties of barium titanate. Materials Chemistry and Physics, 78 (3). pp. 702-710. ISSN 0254-0584

Sarkar, Ritwik and Chatterjee, S and Mukherjee, B and Tripathi, Himansu Shekhar and Haldar, Manas Kamal and Das, S K and Ghosh, A (2003) Effect of alumina reactivity on the densification of reaction sintered nonstoichiometric spinels. Ceramics International, 29 (2). pp. 196-198. ISSN 0272-8842

Mistry, Kalyan Kumar and Basu, S and Chatterjee, S and Saha, M and Chattopadhyaya, D and Sengupta, Kamalendu (2003) Sensitivity and selectivity of porous tape cast material for gas moisture sensing. Journal of Porous Media, 6 (4). pp. 267-272. ISSN 1091-028X

Basu, S and Chatterjee, S and Saha, M and Bandyopadhay, S and Mistry, Kalyan Kumar and Sengupta, Kamalendu (2001) Study of electrical characteristics of porous alumina sensors for detection of low moisture in gases. Sensors and Actuators B: Chemical, 79 (2-3). 182 -186 . ISSN 0925-4005

Chatterjee, S and Basu, S and Chattopadhyay, D and Mistry, Kalyan Kumar and Sengupta, Kamalendu (2001) Humidity sensor using porous tape cast alumina substrate. Review of Scientific Instruments, 72 (6). 2792 -2795. ISSN 0034-6748

Chatterjee , S and Maiti, Himadri Sekhar (2001) A novel method of doping PTC thermistor sensor elements during sintering through diffusion by vapour phase. Materials Chemistry and Physics, 67 (1-3). 294 -297. ISSN 0254-0584

Chanda, A and Mukhopadhyay, Anoop Kumar and Basu, Debabrata and Chatterjee, S (1997) Wear and friction behaviour of UHMWPE - Alumina combination for total hip replacement. Ceramics International, 23 (5). pp. 437-447. ISSN 0272-8842

Dasgupta, A and Basu, Debabrata and Chatterjee, S and Basu , M K (1995) Variation of surface profile of various job materials machined by different tools under varied cutting parameters. Transactions of Powder Metallurgy Association of India, 22. p. 135.

Chanda, A and Basu, Debabrata and Chatterjee, S and Basu, M K (1995) Wear and friction behaviour of biomaterials for total hip replacement. Transactions of Powder Metallurgy Association of India, 22. p. 40.

Sinha, Mithiles Kumar and Chatterjee, S and Basu, Debabrata and Basu, M K (1995) Synthesis, characterization and fabrication of hydroxyapatite ceramics. Journal of the Indian Chemical Society, 72 (10). pp. 771-773. ISSN 0019-4522

Sinha, Mithlesh Kumar and Chatterjee, S and Basu, Debabrata and Basu, M K (1994) Strength hardness and microstructure of 2Y.PSZ-Al2O3 composites prepared from commercial powders. Journal of Materials Science Letters, 13 (6). pp. 447-450. ISSN 0261-8028

Chatterjee, S and Basu, Debabrata and Sinha, Mithlesh Kumar and Das, R and Basu, M K (1994) Development of alumina ceramic head for hemi-hip joint prosthesis and its short term clinical report. Transactions of the Indian Ceramic Society, 53 (5). pp. 123-126. ISSN 0371-750X

Chanda, A and Basu, Debabrata and Chatterjee, S and Basu, M K (1994) Effect of contact pressure and interfacial relative velocity on the friction and wear properties of alumina-UHNWPE combination for total hip-joint replacement. CGCRI Bulletin, 41 (1-2). pp. 5-9. ISSN 0008-9397

Basu, Debabrata and Chatterjee, S and Sinha, Mithlesh Kumar and Basu, M K (1992) Effect of grinding and subsequent annealing on the properties of transformation-toughened alumina ceramics. Journal of Materials Science Letters, 11 (9). pp. 564-566. ISSN 0261-8028

Sinha, Mithlesh Kumar and Chatterjee, S and Basu, Debabrata and Basu, M K (1992) Preparation of Y-PSZ ceramics from commercial grade zirconia powder. Transactions of the Indian Ceramic Society, 51 (3). pp. 60-62. ISSN 0371-750X

Sinha, M K and Basu, Debabrata and Chatterjee, S and Basu, M K (1991) Effect of dopant concentration on the dilation behavior of Mg-PSZ. Journal of Materials Science Letters, 10 (22). pp. 1352-1355. ISSN 0261-8028

Basu , D and Chatterjee, S and Das, R and Guha, S K (1990) Role of ZrO2 and TiC on performance of alumina based ceramic cutting tools. Transactions of the Indian Ceramic Society, 49 (3). pp. 60-66. ISSN 0371-750X

Chatterjee, S and Basu, Debabrata and Das, R and Guha, S K (1989) Evaluation of mechanical properties of sintered zirconia toughened alumina ceramics. Transactions of the Indian Ceramic Society, 48 (4). 68-72, 75. ISSN 0371-750X

Sinha, Mithlesh Kumar and Chatterjee, S and Basu, Debabrata and Guha, S K (1989) Influence of powder preparation on the mechanical properties of partially stabilized zirconia. Transactions of the Indian Ceramic Society, 48 (6). pp. 111-114. ISSN 0371-750X

Guha, S K and Chatterjee, S and Das Gupta, A (1981) Thermal endurance studies on some fired saggar bodies. Transactions of the Indian Ceramic Society, 40 (6). pp. 209-211. ISSN 0371-750X

Guha, S K and Chatterjee, S (1980) Effect of lapping and polishing on the strength of alumina ceramics. Transactions of the Indian Ceramic Society, 39 (4). pp. 127-130. ISSN 0371-750X

Conference or Workshop Item

Das Chowdhury, S and Pal, Atasi and Pal, D and Chatterjee, S and Paul, Mukul Chandra and Sen, Ranjan and Pal, Mrinmoy (2017) Sub 100 NS TM Gain-Switched Fiber Laser Pumped by Rectangular Pulse Er: Yb Fiber Laser and Effect on Tissue Ablation. In: 2017 IEEE Workshop on Recent Advances in Photonics (WRAP), DEC 18-19, 2017, Mahindra Ecole Centrale, Hyderabad, INDIA.

Ghosh, S and Chatterjee, S and Kundu, A and Maity, S and Saha, H (2012) Thermal analysis of cantilever MEMS based Low power microheater array for the selective detection of explosive and toxic gases. In: 1st International Symposium on Physics and Technology of Sensors, ISPTS-1, 8 -10 March, 2012, Pune.