Article

Baral, S C and Basu, M K and Roy, S (1997) Potentiality of common clay in ceramic industry. Transactions of the Indian Ceramic Society, 56 (3). pp. 88-90. ISSN 0371-750X

Basu, Debabrata and Das Gupta, A and Basu, M K and Sarkar, Bijit Kumar (1996) Ageing of zirconia-toughened alumina ceramics under different hydrothermal conditions. Journal of the European Ceramic Society, 16 (6). pp. 613-617. ISSN 0955-2219

Dasgupta, A and Basu, Debabrata and Chatterjee, S and Basu , M K (1995) Variation of surface profile of various job materials machined by different tools under varied cutting parameters. Transactions of Powder Metallurgy Association of India, 22. p. 135.

Chanda, A and Basu, Debabrata and Chatterjee, S and Basu, M K (1995) Wear and friction behaviour of biomaterials for total hip replacement. Transactions of Powder Metallurgy Association of India, 22. p. 40.

Sinha, Mithiles Kumar and Chatterjee, S and Basu, Debabrata and Basu, M K (1995) Synthesis, characterization and fabrication of hydroxyapatite ceramics. Journal of the Indian Chemical Society, 72 (10). pp. 771-773. ISSN 0019-4522

Dasgupta, A and Sen, P S and Sinha, Mithlesh Kumar and Basu, M K (1994) Effect of ZrO2 addition on strength and dilation behaviour of cordierite ceramics. Journal of Materials Science Letters, 13 (5). pp. 332-334. ISSN 0261-8028

Sinha, Mithlesh Kumar and Chatterjee, S and Basu, Debabrata and Basu, M K (1994) Strength hardness and microstructure of 2Y.PSZ-Al2O3 composites prepared from commercial powders. Journal of Materials Science Letters, 13 (6). pp. 447-450. ISSN 0261-8028

Chatterjee, S and Basu, Debabrata and Sinha, Mithlesh Kumar and Das, R and Basu, M K (1994) Development of alumina ceramic head for hemi-hip joint prosthesis and its short term clinical report. Transactions of the Indian Ceramic Society, 53 (5). pp. 123-126. ISSN 0371-750X

Chanda, A and Basu, Debabrata and Chatterjee, S and Basu, M K (1994) Effect of contact pressure and interfacial relative velocity on the friction and wear properties of alumina-UHNWPE combination for total hip-joint replacement. CGCRI Bulletin, 41 (1-2). pp. 5-9. ISSN 0008-9397

Mazumder, Sujata and Mukherjee, B and Basu, M K (1993) Quantitative estimation of crystalline phases of cordierite-mullite-based kiln furniture by X-ray diffraction method. Transactions of the Indian Ceramic Society, 52 (5). pp. 159-162. ISSN 0371-750X

Basu, Debabrata and Chatterjee, S and Sinha, Mithlesh Kumar and Basu, M K (1992) Effect of grinding and subsequent annealing on the properties of transformation-toughened alumina ceramics. Journal of Materials Science Letters, 11 (9). pp. 564-566. ISSN 0261-8028

Sinha, Mithlesh Kumar and Chatterjee, S and Basu, Debabrata and Basu, M K (1992) Preparation of Y-PSZ ceramics from commercial grade zirconia powder. Transactions of the Indian Ceramic Society, 51 (3). pp. 60-62. ISSN 0371-750X

Sinha, M K and Basu, Debabrata and Chatterjee, S and Basu, M K (1991) Effect of dopant concentration on the dilation behavior of Mg-PSZ. Journal of Materials Science Letters, 10 (22). pp. 1352-1355. ISSN 0261-8028

Srinivasan, K N and Basu, M K (1983) Rapid assessment of clay fineness by dye adsorption. Transactions of the Indian Ceramic Society, 42 (4). pp. 101-103. ISSN 0371-750X

Manian, R B V S and Rathor, B S and Vyas, D R and Basu, M K (1982) Evaluation of the Surajdewal sand for the glass industry. Transactions of the Indian Ceramic Society, 41 (4). pp. 110-112. ISSN 0371-750X

Basu, M K and Nayak, U N and Lele, R V (1979) Energy requirements and fuel efficiency in whiteware industry. Transactions of the Indian Ceramic Society, 38 (1). pp. 44-48. ISSN 0371-750X